







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Bathroom Remodeling: The Ventura Owner’s Guide
A full Schluter-system bathroom remodel in Ventura typically runs $9,000 to $28,000 installed, depending on shower size, waterproofing scope, and whether we’re redoing the pan, walls, or the entire room. Most Schluter failures we see aren’t the membrane itself, they’re installation errors from the first contractor, bad corners, wrong thin-set, missing banding. The symptom picture is usually the same: grout cracking in a line, water staining a ceiling below, or tile that sounds hollow when you tap it.
Ventura’s coastal humidity and older mid-century homes make waterproofing the one place you don’t cut corners. When a Schluter system fails, it fails slowly and quietly, until the drywall behind the tile is mush and you’re looking at a full tear-out instead of a repair.
Key takeaways:
- Installed Schluter bathroom remodels in Ventura run $9,000 – $28,000; shower-only work starts around $4,500.
- We stock Schluter KERDI membrane, KERDI-BAND, corners, and DITRA on hand for repairs and full builds.
- Most failures trace back to skipped banding at seams, wrong thin-set, or missing slope in the pan, not defective membrane.
- Every job gets a written price before work starts and a Done Right Promise after it’s done.
Which Schluter Models This Applies To

Schluter makes one waterproofing system with several product lines, not a dozen competing models. The core pieces are KERDI membrane (the orange fabric that goes on walls and shower floors), KERDI-BAND (the seam tape), pre-formed KERDI-BOARD wall panels, DITRA and DITRA-HEAT underlayment for bathroom floors, and KERDI-LINE or KERDI-DRAIN floor drains. Your shower was built with some combination of these, and the failure point is almost never the membrane sheet itself. It’s the seam, the corner, or the drain connection.
If you’re standing in a failing shower and want to know what you have, look for orange fabric at any exposed edge, a square drain grate, or the Schluter name stamped on the drain ring. Measure your tile: Schluter pans are commonly set up for 2×2 floor tile on the slope, while walls can handle larger formats. We’re an independent Ventura contractor, not a Schluter affiliate, which matters because we install the system without pushing you into one product line for the sake of it. OEM Schluter parts are the spec; there are aftermarket waterproofing membranes that claim equivalency, but when a seam fails, matching the original KERDI-BAND and thinset chemistry is the only repair worth doing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Bathroom Remodeling Is Failing
- Water stain on the ceiling below the bathroom. This is the classic. When a shower pan corner or drain connection leaks, water travels down and shows up as a soft, yellow-brown ring on the ceiling of the room underneath.
- Grout cracks running in straight lines or right angles. Grout should crack randomly if it’s just settling. Straight-line cracks following a seam or corner usually mean the KERDI-BAND was skipped or poorly embedded there, and movement is opening the joint.
- Hollow-sounding tile when you tap it. Tile that’s lost its bond to the substrate makes a distinct hollow ‘thock’ instead of a solid ‘tick.’ Over a Schluter membrane, this almost always means the wrong thin-set was used (modified instead of unmodified, or vice versa depending on the substrate) or the membrane was set over a wet, dusty, or improperly prepped surface.
- Musty smell that never leaves, even after cleaning. Water trapped behind tile and membrane grows mold in the wall cavity. You smell it long before you see it, especially in Ventura’s humid coastal air.
- Loose or shifting floor tile near the drain. A Schluter pan that wasn’t properly bedded in thin-set, or a drain flange that wasn’t sealed with KERDI-FIX, lets tile flex underfoot. That movement cracks grout and invites water through.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Ventura, a full Schluter bathroom remodel lands between $9,000 and $28,000. A smaller bathroom or a shower-only redo runs $5,000 to $12,000, while a walk-in shower with a new Schluter pan and KERDI-BOARD walls starts around $4,500 and goes up with size, tile choice, and plumbing changes. What drives the spread is scope: are we gutting to the studs and rebuilding the entire waterproofing envelope, or pulling off failed tile, patching the membrane, and re-tiling a single wall?
Every estimate includes the Schluter membrane, banding, corners, drain assembly, thin-set, tile, grout, sealant, labor, and debris hauling, written line by line. No allowances, no ‘we’ll see when we open the wall’ pricing games. The number you approve is the number you pay, and the Done Right Promise backs the work for a full year after we close out the job. Call (831) 604-3426 for a written, line-item estimate.
DIY or Call Us?
You can safely do the detective work: run the shower, watch for pooling near the drain, check for soft spots in the floor, and look for ceiling stains below. What you shouldn’t do is cut into a Schluter membrane and try to patch a seam yourself. Waterproofing is a system, not a patch. A repair that misses a pinhole or fails to overlap the banding correctly just moves the leak six inches to the left, and now you’ve spent a weekend and a few hundred dollars to still need a tear-out.
Schluter work is precision work with exact thin-set requirements and cure times, and a failed waterproofing job isn’t a cosmetic problem. It’s a structural problem behind your walls. If you’re in Ventura and the signs point to a leaking shower, call (831) 604-3426. We’ll look, tell you straight what’s failing, and hand you a written price before any work starts.
FAQs

A properly installed Schluter KERDI system should last 25 years or more. The membrane itself is a polyethylene sheet that doesn’t rot, rust, or break down the way older hot-mop or vinyl liner systems do. What fails first in Ventura, where humidity and older framing are common, is almost never the membrane. It’s the installation: skipped KERDI-BAND at seams, wrong thin-set, or substrate movement cracking the tile and letting water in. Installed correctly, the system outlives the tile on top of it. If your Schluter shower is failing after 5 or 10 years, the system wasn’t installed to spec. Call (831) 604-3426 and we’ll tell you what we’re seeing.
Yes, if the failure is caught early and localized to one wall or one corner. We can remove the tile in that section, patch the membrane with new KERDI-BAND and KERDI-FIX, re-tile, and re-grout. If the pan or drain failed, or water has been sitting in the wall cavity long enough to soften the framing, you’re looking at a full or partial tear-out. The honest answer depends on what we find when we open the wall, which is exactly why we walk you through before-and-after photos so you see what we see. Call (831) 604-3426 for a free inspection and a straight answer.
A shower-only Schluter rebuild with a new pan, KERDI-BOARD walls, and tile typically takes 5 to 7 working days, including thin-set cure times and a 24-hour flood test before tile goes on. A full bathroom remodel runs 2 to 3 weeks, depending on plumbing changes, custom tile work, and whether we’re moving a vanity or toilet. The flood test alone takes a full day, and it’s the part you don’t skip. We don’t rush cure times, and we don’t cut corners on the waterproofing sequence. Call (831) 604-3426 for a schedule based on your exact bathroom.
We stock KERDI membrane, KERDI-BAND, inside and outside corners, pipe seals, KERDI-FIX sealant, DITRA underlayment, and drain assemblies on hand. That means most repairs and full builds start the day we arrive, not after a week of waiting on shipping. If your shower was built with an older Schluter drain model that’s been discontinued, we can usually adapt the current KERDI-DRAIN to the existing plumbing without tearing out the subfloor. We also carry KraftMaid cabinetry, Cambria and Silestone countertop materials, and other name-brand finishes for the surrounding remodel. Call (831) 604-3426 and we’ll tell you what’s on hand today.
Written by Sawyer Remodel Ventura, Sawyer Remodel Ventura at Sawyer Remodel Ventura, serving Ventura and nearby areas.


