







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sterling Driveway & Pavers: The Ventura Owner’s Guide
Sterling driveway and paver systems are built tough, but when a section fails, it tends to fail visibly: a cracked paver, a sunken edge, or a shifted row that collects water after every rain. In Ventura, we stock Sterling-compatible pavers and edge restraints, and most driveway paver repairs run $7,000 – $18,000 for full replacement or $350 – $1,200 for spot repairs depending on the damage. Most owners call us after spotting a trip hazard or noticing the driveway no longer drains the way it did last year.
What we see most often in Ventura is not a manufacturing defect. It’s our soil. Clay-heavy ground expands and contracts with our wet winters and dry summers, and over time that movement works pavers loose. Add a vehicle load on top and you get the classic failure: a paver that’s cracked straight through, or an edge that’s dropped half an inch below its neighbor. The part itself matters less than what’s underneath it, and that’s the conversation we have on every Sterling paver call.
Which Sterling Models This Applies To

Sterling’s paver lineup spans several product families, and the parts are not interchangeable across all of them. The three series we encounter most in Ventura driveways are the Holland Stone (rectangular, 4″x8″ nominal), the Winstone (a tumbled, irregular-edge paver), and the Plaza Stone (larger format, often 12″x12″ or 16″x16″ for heavy vehicle use). Each has its own thickness spec: Holland runs 60mm, Winstone 60 – 80mm depending on the application, and Plaza Stone is typically 80mm for driveway-rated loads.
The compatibility gotcha owners hit: color lots. Sterling manufactures in batches, and a paver made in 2019 will not match a paver made in 2024, even with the same color name. If you’re replacing a single section, you’ll likely blend old and new pavers rather than get a perfect match. For a true OEM match, the original lot number from the delivery pallet is the gold standard, but after a few years of Ventura sun, even that washed-out color won’t match a fresh paver. Our take: OEM Sterling pavers are worth it when you’re replacing half a driveway and want structural consistency. For a handful of broken units, high-quality aftermarket concrete pavers from a local Ventura supplier get you 90% of the look at 60% of the cost. We’ll walk you through both before you commit.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Sterling Driveway & Pavers Is Failing
- Water pooling in low spots after rain. This means the sand bedding or gravel base has settled. Left alone, it accelerates freeze-thaw damage in winter and softens the subgrade, so the problem spreads outward from the original dip.
- Visible cracks running through individual pavers. A single cracked paver is usually impact or point-load damage. A whole row of cracked pavers in a line usually means a base failure underneath, often from a buried tree root or an uncompacted utility trench.
- Edge pavers creeping outward or separating from the curb. When the plastic or aluminum edge restraint fails, the outer pavers start to walk. You’ll see the gap widen at the driveway’s edge while the center stays tight.
- Sand washing out between joints after every rain or hose-down. Lose the joint sand and the pavers start grinding against each other, chipping edges and loosening the interlock that gives paver driveways their strength.
- Rocking or shifting underfoot. Stand on a paver and feel movement. That’s not the paver’s fault. It means what’s underneath has stopped supporting it, and pavement without support becomes a crack factory in months, not years.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Ventura, a full Sterling paver driveway replacement runs $7,000 – $18,000 installed, depending on square footage, access, and whether we’re reusing the existing base or excavating and rebuilding from subgrade. Spot repairs for a few broken or sunken pavers fall between $350 and $1,200, including new bedding sand, replacement pavers, and re-sanding the joints.
What drives the range at the high end is a bad base. If we pull up pavers and find 2 inches of sand sitting on loose fill, that’s a re-excavation job: dig out, compact, add proper road base, then relay. That’s what separates a driveway that lasts 25 years from one that heaves again in three. Every repair includes new joint sand and compaction, and every project comes with our written price before work starts and the Done Right Promise backing the install. No change orders at the door, no surprises on the invoice.
DIY or Call Us?
You can safely check the obvious: look for cracked units, feel for rocking, and watch where water sits after rain. Mark the bad spots with chalk and take photos. That’s useful.
Here’s where DIY goes sideways: pulling pavers without a plate compactor, re-leveling with play sand from the hardware store, or ignoring the edge restraint. Play sand is too fine and washes out within a season. A plate compactor rental runs you $80 a day, and if you don’t compact in lifts you’ll redo the job in two years. Pavers are heavy, the work is back-breaking, and getting the slope right so water runs off instead of pooling is a skill. If seeing the job done right the first time matters more than saving a weekend, call us at (831) 604-3426 and we’ll get you a written estimate.
FAQs

A properly installed Sterling paver driveway in Ventura lasts 25 to 30 years, with joint sand re-topping every 5 to 7 years as normal maintenance. The pavers themselves rarely wear out; it’s the base and sand that need attention.
Yes, in most cases we replace individual broken or sunken pavers for $350 – $1,200, re-setting them in fresh bedding sand and re-sanding the surrounding joints. If the base underneath has failed, a spot repair is temporary and the full section will need re-base work. Call (831) 604-3426 and we’ll tell you which situation you’re in.
A spot repair of 5 to 20 pavers takes one day, including removal, base prep, re-setting, and joint sand. A full driveway replacement in Ventura runs 3 to 5 days depending on square footage and whether we’re rebuilding the base. You’ll get a timeline in the written quote.
We carry a range of replacement pavers and edge restraints on hand for common Ventura jobs, and we source Sterling-specific colors and sizes from local suppliers within 2 to 3 business days for larger repairs. We’ll confirm availability before we schedule.
No. Sawyer Remodel Ventura is an independent service provider in Ventura. We install and repair Sterling driveway and paver products, and we also work with materials from KraftMaid, Cambria, and Silestone on our broader remodeling projects. We’re not a manufacturer warranty center, but we’ll document everything you need for a warranty claim.
If your Sterling driveway or pavers are cracked, sunken, or draining wrong, call us at (831) 604-3426. The work says it. We just show up and cut straight.
Written by Sawyer Remodel Ventura, Sawyer Remodel Ventura at Sawyer Remodel Ventura, serving Ventura and nearby areas.


