







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Home Additions & ADU: The Ventura Owner’s Guide
We install and build Tamko-sheathed home additions and ADUs throughout Ventura, and a full addition or ADU project typically runs $45,000 – $130,000 for the structure, depending on square footage, foundation work, and finish level. Most Ventura owners call us because the Tamko roofing or weather barrier on their existing addition is failing after years of salt air and sun, and the leaks have started working into the framing. Sometimes the issue is the Tamko decking or underlayment delaminating around vents and flashings in Midtown and Pierpont homes built in the 60s and 70s. The fix usually means tearing back the failed section, replacing rotted sheathing, and re-flashing the whole penetration properly.
Which Tamko Models This Applies To
Tamko makes a full line of building products that show up on Ventura additions and ADUs: Heritage and Elite Glass-Seal shingles, TW MetalWorks panels, and their decking and underlayment lines. The compatibility gotcha on most additions we see is that the original builder used Tamko shingles on the roof but a different brand of underlayment below them, and the two systems don’t always fail at the same rate. If your addition was built with Tamko MetalWorks siding or roofing, the panel profile and gauge matter for replacement parts – you can’t just swap in any standing seam panel and expect the laps to line up. We stock Tamko-compatible fasteners, closures, and trim profiles on hand for the most common profiles we see in Ventura, plus a solid aftermarket selection that matches Tamko’s specs without the OEM markup on discontinued colors.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Home Additions & ADU Is Failing
- Water staining at the addition’s roofline where it ties into the main house. This is the most common failure point on Ventura additions. The transition flashing between the new roof and the original roof gets torn by wind or thermal movement, and water follows the seam into the ceiling. Once the drywall shows a stain, the sheathing has been wet for a while.
- Granules collecting in gutters or at downspout elbows after rain. Tamko shingles shed granules as they age, but if you’re seeing a steady buildup while the neighbor’s roof stays put, the shingle mat is breaking down faster than it should. Salt air accelerates this on homes west of the 101 in Ventura.
- Soft spots or springiness on the addition’s roof deck when walked. That means the Tamko decking or the sheathing below the underlayment has absorbed moisture and is starting to rot. In Ventura’s marine layer climate, once moisture gets trapped under a failed underlayment it doesn’t dry out on its own.
- Daylight visible at the ridge or at wall-to-roof intersections when you look from inside the attic. This is a flashing or closure failure, and it’s the one that lets in both water and critters. We see it constantly on additions built in the 80s and 90s when the original Tamko closures were staples rather than the compression-fit ones we use now.
- Lifted or curled shingle edges on the south and west exposures. Ventura sun is relentless on those elevations. Once the Tamko shingle seal strip fails, the edges lift, wind gets under them, and the next big blow tears whole courses off. You’ll usually spot it first on the side of the addition facing the afternoon sun.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a Tamko home addition or ADU project in Ventura, plan on $45,000 – $130,000 depending on the scope. A simple bedroom addition with a roofline tie-in runs the lower end; a full ADU with a kitchen, bath, and separate meter panel runs the higher end. The difference comes down to foundation type, seismic detailing, utility runs, and how much of the existing structure has to be re-framed once we open it up. Every quote you get from us includes the parts, the labor, the permit, and the written warranty in one number that doesn’t change at the door. We walk the site with you, open the walls where we need to, and hand you a line-by-line written price before any work starts. If we open something and find more rot than expected, you know the price for the fix before we cut a single board.
DIY or Call Us?
If you’re comfortable on a ladder, you can check your Tamko addition for the symptoms above – look for lifted shingles, pooling water, stained fascia, and granules in the gutter. That’s a good Saturday inspection. But once you find a failure, leave the repair to someone who works on these systems daily. Removing shingles or metal panels on a two-story Ventura addition means working at height while handling materials that weigh more than they look, and a bad flashing job hides water damage behind walls for years before you find it. That’s not a warning to scare you; it’s the honest truth. One wrong move on a 30-foot eave is permanent, and the savings aren’t worth it. Call (831) 604-3426 and we’ll come look at it.
FAQs

A properly flashed and installed Tamko addition in Ventura should give you 20 – 30 years on the roof system before you’re doing real rework. The marine layer and salt air west of the 101 shave a few years off compared to inland, and additions with the original 2000s-era underlayment are hitting end of life now. A well-built addition frame, on the other hand, outlasts the roof and siding by decades.
Yes, if the failure is localized – a torn flashing, a handful of lifted shingles, one metal panel with a bad closure – we repair it and warranty the work. If the failure is widespread granule loss or the underlayment has become brittle across the whole plane, you’re throwing money at spot repairs that won’t hold. We’ll tell you which one you have and show you photos either way. Call (831) 604-3426 for an exact assessment.
Most full addition or ADU projects in Ventura run 8 – 16 weeks from permit to final inspection. A roof or weather-barrier repair on an existing addition runs 2 – 5 days once we’re on site, depending on how much sheathing has to come out. We schedule around Ventura’s coastal fog and avoid open-roof work on days when marine layer moisture makes the decking slick.
We stock the most common Tamko-compatible fasteners, closures, ridge caps, and trim profiles on hand, plus a curated set of aftermarket options that match the specs without the discontinued-color headaches. For less common profiles or specific color matches, we order direct and usually have parts in hand within a week. We’re an independent service provider and not affiliated with Tamko, so our recommendation is based on what performs, not what brand name is on the wrapper.
If your Tamko addition or ADU in Ventura is showing signs of failure, don’t wait for the next storm to find the leak. Call (831) 604-3426 and we’ll schedule a free estimate, walk the roof with you, and hand you a written price before any work begins.
Written by Sawyer Remodel Ventura, Sawyer Remodel Ventura at Sawyer Remodel Ventura, serving Ventura and nearby areas.


