







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
PGT Driveway & Pavers: The Ventura Owner’s Guide
We stock and install PGT-compatible driveway pavers in Ventura, with full paver driveway replacement running $7,000 – $18,000 installed, and targeted section repairs starting around $1,200. Most Ventura owners call us after a paver cracks, sinks, or shifts out of alignment and they’re trying to figure out whether to patch it or replace the whole run. You’re not crazy for noticing it early: when one PGT paver fails, the ones around it take on the load and start failing right behind it. Sawyer Remodel Ventura is an independent service provider, not affiliated with PGT, but we work with their paver profiles every week and keep common PGT-compatible units on hand for fast section work.
Key Takeaways:
- Full PGT-compatible driveway replacement in Ventura runs $7,000 – $18,000 depending on square footage, base condition, and edge restraint work.
- Section repair (3 – 5 pavers) typically runs $1,200 – $3,500 including base recompaction and sand rejointing.
- PGT’s paver line is sized to interlock tight, which means a single shifted paver usually means the edge restraint failed first, not the paver.
- We give you a written price before any work starts, and the Done Right Promise covers every paver repair we install.
Which PGT Models This Applies To

PGT sells their driveway pavers under a few different profile names depending on the year and the distributor, and the naming has shifted over time. What matters for matching isn’t the series name painted on the pallet wrap: it’s the physical profile. PGT’s standard driveway units run roughly 60mm thick in a 4×8 or 6×9 face dimension, with either a square edge or a chamfered edge that creates a tighter joint than most box-store pavers. The gotcha we see in Ventura: two PGT pavers can look identical on the face but be from different production runs with enough tolerance drift that they won’t seat correctly side by side. We ask owners to check the underside of any spare paver for the mold code stamped into the concrete, and measure thickness with a tape before we match anything.
On OEM versus aftermarket: PGT’s own units are high-quality concrete, but there are aftermarket interlock units from Ventura supply yards that match the face size and thickness well enough for section repair. We’ll give you the straight answer on when aftermarket saves you money and when it’ll look wrong in two years. For visible front-driveway sections, we recommend PGT-compatible units from the same profile family. For side-yard or back-pad patches, quality aftermarket is usually fine.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your PGT Driveway & Pavers Is Failing
- One sunken paver in a traffic lane. This almost always means the compacted base under it has washed out or settled, usually after a Ventura winter rain cycle. Left alone, that low spot collects water and the settlement spreads outward in a widening circle.
- Edge pavers drifting toward the lawn or street. The edge restraint, the concrete or plastic lip that holds the outside row, has cracked or pulled loose. Once the edge goes, the whole field can walk apart within a season.
- Cracks running through multiple pavers in a line. A straight-line crack pattern signals base failure or a root pushing up from underneath, not a bad batch of pavers. Replacing pavers without fixing the base means doing the job twice.
- Joint sand washing out after every rain. PGT’s tight joints depend on fine polymeric sand staying locked in place. When water runs through, it carries the sand out and the pavers start shifting lock-to-lock.
- Weeds pushing up through joints in one concentrated area. That’s usually organic material and fine soil replacing the joint sand, which means the sand below grade has already failed. The weeds are a symptom, not the problem.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Full PGT-compatible driveway paver replacement in Ventura runs $7,000 – $18,000. The spread comes down to three things: total square footage, whether the existing base is salvageable, and access. A 400-square-foot two-car driveway with a decent existing base lands near the bottom of that range. A long, wide, or sloped driveway with failing base material, or one that needs new edge restraint and drainage work, climbs toward the top.
We write the price before we pick up a tool, and the number on the invoice is the number you approved. Every paver job includes base recompaction, joint sand, and edge restraint repair in the quote, not as a surprise line item later. The work carries the Done Right Promise: if it’s not right, we make it right, for a full year after the job closes. We also stock common PGT replacement parts on hand in Ventura, so section work doesn’t wait on a special order when we can avoid it.
| Scope | Typical Ventura Installed Range |
|---|---|
| Single paver replacement + sanding | $200 – $500 |
| Section repair (3 – 5 pavers, base recompaction) | $1,200 – $3,500 |
| Half-driveway replacement | $3,500 – $8,000 |
| Full driveway replacement (400 – 900 sq ft) | $7,000 – $18,000 |
| Edge restraint repair only | $400 – $1,500 |
DIY or Call Us?
Paver work sits in a weird middle zone: it’s not high-tension dangerous like a garage spring, but the failure is below the surface, and that’s where DIY goes wrong. What you can safely check: measure the thickness of a loose paver, note the mold code underneath, and take photos in good light. That helps us match PGT-compatible units before we come out. What you shouldn’t do: pull up a half-dozen pavers and re-set them yourself without recompacting the base. A paver that wobbles on a soft base will resettle within a season, and now you’ve paid twice and saved nothing.
If you’re in Ventura and the driveway is shifting, call (831) 604-3426. We’ll come look, measure what’s actually failing underneath, and give you a written price for the fix before anything starts.
FAQs

PGT-compatible concrete driveway pavers typically last 20 – 30 years in Ventura’s coastal climate, provided the base was compacted right when they went in. The pavers themselves rarely fail; the base, edge restraint, and joint sand go first, usually around year eight to twelve. Rainy winters accelerate washout. Call (831) 604-3426 for a free inspection if yours are shifting early.
Yes, and we do section repairs all the time in Ventura. If the base is still stable and only a few pavers are cracked or sunken, we pull the section, recompact, reset the units, and rejoint with fresh sand for $1,200 – $3,500 depending on how many pavers and how deep the problem goes. If the base is failing, section repair becomes temporary, and we’ll tell you that before quoting.
A full driveway replacement on an average two-car pad in Ventura takes three to five working days from excavation to final sanding and compaction. Section repairs are usually same-day. Weather and base surprises are the main variables, and we give you a live arrival time plus photo updates before and after so you’re never guessing.
We keep common PGT-compatible driveway profiles on hand for section work. For full replacements or unusual face sizes, we source from Ventura supply yards with a two-to-five day lead time. Either way, the price is written before we order anything, so you know the full number up front. Call (831) 604-3426 for a free estimate.
Written by Sawyer Remodel Ventura, Sawyer Remodel Ventura at Sawyer Remodel Ventura, serving Ventura and nearby areas.


