







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Driveway & Pavers: The Ventura Owner’s Guide
CWS-compatible driveway and paver replacement in Ventura typically runs $7,000 – $18,000 installed, and most full replacements take 3 – 5 working days once materials land. We keep common CWS paver profiles and edge restraints in stock, and we can usually get less common sizes from our Ventura suppliers within 48 hours. The way most owners find out a part has failed is simple: a paver shifts underfoot, a border course pulls away after a rain, or a low spot starts holding water where it never did before.
Sawyer Remodel Ventura is an independent contractor. We’re not affiliated with CWS or its distributors. What we do is match their pavers and driveways to the right replacement parts, at a written price, and install them so the repair doesn’t turn into a second repair next winter.
Which CWS Models This Applies To

CWS driveway systems fall into two broad groups that matter for parts matching. The first is interlocking concrete pavers, usually 60mm thick for driveways and 80mm for commercial aprons. The second is paver-over-slab systems, where a CWS base grid sits on existing concrete and the pavers lock into it. The part you need depends on which system you have, and the fastest way to tell is to pull up one paver at the edge and look underneath.
Here’s the compatibility gotcha we run into constantly in Ventura: CWS 60mm driveway pavers are not interchangeable with the 40mm patio versions, even when the visible face looks identical. The 40mm paver will crack under vehicle load within a season or two. If you’re replacing a section, measure the paver thickness, not just the surface pattern. OEM CWS pavers carry a molded ID code on the underside, usually a two or three letter stamp near one corner. Quality aftermarket equivalents from local Ventura stone yards can match the face color well, but they won’t have that stamp, and their color batch will fade at a different rate than surrounding OEM pavers. For a patch job under 20 square feet, aftermarket is fine. For anything larger, we recommend staying with CWS OEM to keep the color uniform.
We also stock replacement CWS edge restraints, the plastic or aluminum strips that keep the border course from creeping outward. Those are an easy swap and we carry them on hand in the two most common Ventura profiles.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CWS Driveway & Pavers Is Failing
- Pavers tilt or rock under the car. This means the bedding sand has washed out from underneath, usually at a low point or along the curb line. The paver itself is usually fine; the base has failed.
- Border pavers pull away from the driveway edge. The edge restraint has cracked or come unspiked. Left alone, the whole outer course walks outward a little more every week.
- Low spots hold water for more than an hour after rain. In Ventura’s clay-heavy soil, a low spot means the sub-base settled unevenly. Water sitting there accelerates the next failure.
- Surface color turns chalky or white on one section only. A patch that was replaced at some point with an aftermarket paver will weather differently. It isn’t failing; it just doesn’t match, and it never will.
- Hairline cracks spider across several adjoining pavers. That’s load stress. The most common cause we see in Ventura is a paver thickness mismatch, or a 40mm paver mixed into a 60mm driveway run.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Ventura, a paver driveway replacement runs $7,000 – $18,000, with most single-car residential driveways landing between $8,500 and $12,000. A smaller repair, like replacing a 100-square-foot failed section with new base and OEM pavers, typically runs $1,400 – $2,800. The range depends on access, the size of the failed area, whether we’re matching OEM CWS pavers or a stock aftermarket equivalent, and what the sub-base looks like once we open it up.
Every quote is a written line-item price before any work starts. That number includes demolition of the failed section, base prep, compaction, new bedding sand, the pavers themselves, edge restraint replacement where needed, and clean-up. The invoice you approve is the invoice you pay. Our Done Right Promise covers the repair in writing: if the paver work we install isn’t done right, we make it right at no charge, for a full year.
DIY or Call Us?
Replacing a single cracked paver in the middle of a run is a Saturday job a careful homeowner can handle. You lift the paver with a couple of flat bars, reset the bedding sand, drop in the replacement, and sweep joint sand into the seams. Where DIY goes wrong is when the base has failed. Pulling a full section, recompacting the sub-base, and re-setting the grade takes a plate compactor and a level of base knowledge that isn’t worth learning on your own driveway. Patch the one paver yourself. Call us when the bed has failed under a whole section.
If you’re not sure which one you’re looking at, call (831) 604-3426 and describe what you see. We’ll tell you straight what it likely is, give you a range in dollars, and schedule a free estimate if you want us to look.
FAQs

A properly installed CWS paver driveway in Ventura lasts 25 – 30 years before the pavers themselves degrade, though the base typically needs attention at the 15-year mark. Coastal humidity and our dry summers shorten the effective base life compared to cooler climates.
Yes, individual pavers and small sections can be lifted and re-set when the base underneath is still sound. Replacement is only needed when the sub-base has washed out or settled. A free inspection tells you which one you’re dealing with. Call (831) 604-3426 to schedule one.
Most paver replacement jobs in Ventura take 3 – 5 working days from material arrival to final compaction and joint sand. Small repairs under 50 square feet are usually done in a single day.
We stock common CWS edge restraints and a rotating inventory of standard 60mm driveway pavers in the most frequent Ventura colors. Less common profiles and colors are ordered from local suppliers and typically arrive within two days. KraftMaid, Cambria, and Silestone parts are separate divisions; for CWS, we focus specifically on driveway and paver systems.
No. If a repair uncovers a hidden failure in the sub-grade, we stop work, show you photos, and hand you a written change order before touching anything else. The price on the invoice is the price you approved. That’s The Relay Standard, and it’s the only way we run jobs.
If your CWS driveway or pavers are showing signs of failure and you want a straight answer on cost, call (831) 604-3426. We’ll give you written pricing for the repair before anything starts, and Luca or one of the crew will walk you through what we found and what we’d do. The work says it. We just show up and cut straight.
Written by Sawyer Remodel Ventura, Sawyer Remodel Ventura at Sawyer Remodel Ventura, serving Ventura and nearby areas.


