







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Bathroom Remodeling: The Ventura Owner’s Guide
An IKO bathroom remodel in Ventura typically runs $9,000 to $28,000 installed, depending on the scope, materials, and what’s behind the walls once we open them up. We stock and install IKO-compatible shower bases, wall surrounds, and waterproofing systems, and we can usually start your project within a week or two of the estimate, not months. Most Ventura homeowners call us after a shower pan cracks, a surround starts separating at the seams, or water stains appear on the ceiling below the bathroom. The failure usually starts small: a soft spot in the floor near the drain, a mildew smell that won’t quit, or grout lines that keep cracking no matter how many times you re-caulk them. By the time you see the stain, the water has been working on the subfloor for a while. We fix the part, the damage, and the waterproofing in one pass so you’re not chasing the same leak six months from now.
Sawyer Remodel Ventura is an independent contractor, not affiliated with IKO. We work with IKO products because they’re solid, but our warranty comes from us, in writing, not from the manufacturer’s fine print.
Key Takeaways:
- Installed IKO bathroom remodel in Ventura: $9,000 – $28,000
- We carry IKO-compatible pans, surrounds, and waterproofing on hand
- Written price before any work starts, guaranteed in the contract
- Done Right Promise on every bathroom project
Which IKO Models This Applies To

IKO makes bathroom products under a few different lines, and the compatibility details matter more than most homeowners expect. The two we work with most in Ventura are the IKO AquaLine shower bases and wall surrounds, and the IKO SlopeShield pre-sloped pans used under tile. AquaLine is the direct-to-installer acrylic system: molded bases with matching wall panels, sealed at the seams with the factory trim kit. SlopeShield is the foam-core, pre-sloped substrate that tile gets set on top of. They are not interchangeable, and you can’t mix parts between the two without creating a leak path at the transition.
The gotcha we see most often: an AquaLine base will not seat properly on a SlopeShield pan or a flat mortar bed that wasn’t leveled to IKO’s spec. The base has a specific pitch built into the foam, and if the subfloor underneath isn’t flat within an eighth of an inch over four feet, the acrylic flexes, the drain seal breaks, and the leak starts inside the first year. You can identify which system you have by pulling the drain grate and looking for the IKO part number stamped on the underside of the pan, or by checking the original remodel paperwork. If you’ve got a tiled floor, you’re almost certainly on SlopeShield. If the walls and floor are one continuous molded surface, it’s AquaLine.
We install OEM IKO parts when the model is still in production and we support quality aftermarket equivalents for discontinued lines. The aftermarket pans for discontinued AquaLine models are dimensionally identical, but we always tell you before the material arrives. You’ll never open a box and find a surprise brand.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Bathroom Remodeling Is Failing
IKO products fail in predictable ways, and the earlier you catch it, the less of your Ventura subfloor we have to pull out. Here’s what we see in homes across Midtown, the Avenues, and out near the hills:
- Soft spots in the floor around the drain. This is the subfloor losing its grip on the screws. Water’s been getting under the pan, and every day it sits, the rot spreads further. By the time the floor feels soft, the fix usually involves replacing a section of subfloor, not just the pan.
- Water stains on the ceiling below the bathroom. A ceiling stain below a bathroom is rarely the pipe. It’s usually the pan or the drain assembly leaking at the flange. The stain shows up at the lowest point of the joist bay, which is often a few feet away from the actual leak.
- Grout or caulk that cracks repeatedly in the same corner. That’s movement, and movement in a shower means the waterproofing layer is flexing. On IKO SlopeShield installs, this usually means the substrate wasn’t bedded properly or the framing behind it is shifting. Re-caulking treats the symptom, not the cause.
- A mildew smell that returns within days of cleaning. When water gets trapped between the acrylic surround and the wall board, it never fully dries. The smell comes from the cavity, not the surface. No amount of bleach fixes it because you’re not reaching the water.
- Drain that takes longer to clear, even after snaking. If the drain line is clear but the water still pools, the pan has lost its pitch. That means the base or substrate has warped or settled. The water sits, the seal degrades, and the leak gets worse.
Replacement Cost & What’s Included

In Ventura, a full IKO bathroom remodel runs $9,000 to $28,000. Where you land in that range depends on a few things: whether we’re swapping just the pan and surround or completely gutting the bathroom, how much subfloor needs to come out, whether you want stone or tile on the walls instead of acrylic panels, and what fixtures you choose. A small guest bath where the framing is solid and we’re pulling everything to the studs and rebuilding is on the lower end. A master bath with a custom tile shower, new vanity, and a footprint change is on the higher end.
Every quote breaks down parts and labor line by line. You’ll see exactly what the IKO pan costs, what the waterproofing membrane costs, what the tile or surround costs, and what our labor is for each phase. The price we hand you before work starts is the price you pay. No change orders unless you change the scope.
Our workmanship warranty runs one year through the Done Right Promise. If something that was installed fails in that year, we come back and fix it. Written on the contract, not a handshake.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Replacing a shower pan or a complete IKO surround is not a weekend project. The pan has to be set dead level on a properly prepared subfloor. The drain assembly has to be sealed and tested before any wall panels or tile go up. Waterproofing transitions at the curb, the wall junctions, and the drain collar are where DIY jobs fail, and every one of those failures is hidden behind your finished walls until the damage is already done. If you get one detail wrong, you’re paying for the remodel twice.
What you can do safely: check the drain grate for the IKO part number so you know what you have, take photos of any visible cracks or separating seams, and stop using the shower if you suspect a leak. Then call us at (831) 604-3426. We’ll inspect it, write you a price, and if it’s repairable, we’ll tell you that instead of selling you a full remodel.
FAQs

An IKO shower pan installed correctly on a properly prepared subfloor should last 15 to 20 years in Ventura’s climate. The harder factor here isn’t weather; it’s that older coastal and Midtown homes shift slightly over time, and any movement in the framing works against the pan’s seal. When they fail early, it’s almost always an installation issue, not a product defect.
A cracked acrylic pan cannot be reliably repaired, and a failed drain seal on a pan that’s lost its pitch can only be corrected by pulling and resetting the pan. Surface repairs with epoxy or patching compounds are temporary and void the waterproofing integrity of the floor. If the leak is caught very early and the pan is still structurally sound, we may be able to repair the drain assembly only. Call (831) 604-3426 and we’ll tell you straight which situation you’re in. Estimates are free.
A shower pan and surround replacement takes three to five working days from demo to final caulk. A complete gut-and-rebuild bathroom remodel typically runs three to five weeks, depending on tile work, custom glass, and plumbing rough-in. We’ll give you a schedule in writing before we start, and you’ll get photo updates at every stage through The Relay Visibility Guarantee.
We keep the common AquaLine bases, SlopeShield pans, drain kits, and trim sets on hand and in our local inventory. Discontinued models sometimes need a special order, which adds three to seven business days. We’ll confirm availability before we quote you, so you’re never waiting on a part that we said was in stock. Call (831) 604-3426 to check your model.
Contact Sawyer Remodel Ventura
If your IKO shower pan, surround, or waterproofing is failing, call us at (831) 604-3426. We’ll send a background-checked technician to inspect it, we’ll write you a price before any work begins, and we’ll show you photos of every step until the job is done. The crew work throughout Ventura and the surrounding areas. We also handle full bathroom and kitchen remodels with KraftMaid, Cambria, and Silestone materials when you’re ready for more than a repair. The work says it. We just show up and cut straight.
Written by Sawyer Remodel Ventura, Sawyer Remodel Ventura at Sawyer Remodel Ventura, serving Ventura and nearby areas.


