A Sawyer company - serving Ventura, CA
A new rear addition with a vaulted beamed ceiling and tall windows

Tamko Home Additions & ADU Nationwide

Free Estimate on SiteCalls Answered by a Live Person, 24/7Background-Checked TechniciansA Local Team in Ventura
A finished backyard cottage with a small covered porch
A single-story rear room addition with tall windows and a new patio
A remodeled kitchen with painted cabinets and a farmhouse sink
A remodeled primary bathroom with a soaking tub and walk-in shower
A remodeled living room with built-in shelves around the fireplace
An open kitchen and dining area after a remodel
A freestanding soaking tub in a remodeled primary bathroom
A whole-home remodel with the living, dining and kitchen areas opened up
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Tamko Home Additions & ADU: The Ventura Owner’s Guide

We install and build Tamko-sheathed home additions and ADUs throughout Ventura, and a full addition or ADU project typically runs $45,000 – $130,000 for the structure, depending on square footage, foundation work, and finish level. Most Ventura owners call us because the Tamko roofing or weather barrier on their existing addition is failing after years of salt air and sun, and the leaks have started working into the framing. Sometimes the issue is the Tamko decking or underlayment delaminating around vents and flashings in Midtown and Pierpont homes built in the 60s and 70s. The fix usually means tearing back the failed section, replacing rotted sheathing, and re-flashing the whole penetration properly.

Call (831) 604-3426

Which Tamko Models This Applies To

Tamko makes a full line of building products that show up on Ventura additions and ADUs: Heritage and Elite Glass-Seal shingles, TW MetalWorks panels, and their decking and underlayment lines. The compatibility gotcha on most additions we see is that the original builder used Tamko shingles on the roof but a different brand of underlayment below them, and the two systems don’t always fail at the same rate. If your addition was built with Tamko MetalWorks siding or roofing, the panel profile and gauge matter for replacement parts – you can’t just swap in any standing seam panel and expect the laps to line up. We stock Tamko-compatible fasteners, closures, and trim profiles on hand for the most common profiles we see in Ventura, plus a solid aftermarket selection that matches Tamko’s specs without the OEM markup on discontinued colors.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Tamko Home Additions & ADU Is Failing

  • Water staining at the addition’s roofline where it ties into the main house. This is the most common failure point on Ventura additions. The transition flashing between the new roof and the original roof gets torn by wind or thermal movement, and water follows the seam into the ceiling. Once the drywall shows a stain, the sheathing has been wet for a while.
  • Granules collecting in gutters or at downspout elbows after rain. Tamko shingles shed granules as they age, but if you’re seeing a steady buildup while the neighbor’s roof stays put, the shingle mat is breaking down faster than it should. Salt air accelerates this on homes west of the 101 in Ventura.
  • Soft spots or springiness on the addition’s roof deck when walked. That means the Tamko decking or the sheathing below the underlayment has absorbed moisture and is starting to rot. In Ventura’s marine layer climate, once moisture gets trapped under a failed underlayment it doesn’t dry out on its own.
  • Daylight visible at the ridge or at wall-to-roof intersections when you look from inside the attic. This is a flashing or closure failure, and it’s the one that lets in both water and critters. We see it constantly on additions built in the 80s and 90s when the original Tamko closures were staples rather than the compression-fit ones we use now.
  • Lifted or curled shingle edges on the south and west exposures. Ventura sun is relentless on those elevations. Once the Tamko shingle seal strip fails, the edges lift, wind gets under them, and the next big blow tears whole courses off. You’ll usually spot it first on the side of the addition facing the afternoon sun.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For a Tamko home addition or ADU project in Ventura, plan on $45,000 – $130,000 depending on the scope. A simple bedroom addition with a roofline tie-in runs the lower end; a full ADU with a kitchen, bath, and separate meter panel runs the higher end. The difference comes down to foundation type, seismic detailing, utility runs, and how much of the existing structure has to be re-framed once we open it up. Every quote you get from us includes the parts, the labor, the permit, and the written warranty in one number that doesn’t change at the door. We walk the site with you, open the walls where we need to, and hand you a line-by-line written price before any work starts. If we open something and find more rot than expected, you know the price for the fix before we cut a single board.

DIY or Call Us?

If you’re comfortable on a ladder, you can check your Tamko addition for the symptoms above – look for lifted shingles, pooling water, stained fascia, and granules in the gutter. That’s a good Saturday inspection. But once you find a failure, leave the repair to someone who works on these systems daily. Removing shingles or metal panels on a two-story Ventura addition means working at height while handling materials that weigh more than they look, and a bad flashing job hides water damage behind walls for years before you find it. That’s not a warning to scare you; it’s the honest truth. One wrong move on a 30-foot eave is permanent, and the savings aren’t worth it. Call (831) 604-3426 and we’ll come look at it.

FAQs

A garage converted into a guest room and home office

Getting started with Sawyer in Ventura

Every project starts with a conversation and a written price. Here is how to take the first step.

A project lead measuring a kitchen with the homeowner during a free estimate

Free on-site estimate

A project lead walks the job with you, measures it and hands you a written, line-item price. No obligation.

Book an estimate
A remodeling crew arriving at a home with lumber and tools

Your Ventura team

A local vetted partner works across Ventura and the towns around it, to the same written standard as every Sawyer job.

Areas we serve
A worker laying floor protection and a dust barrier before work starts

Read our written promise

What we promise on every job, written down, with the terms spelled out before any work starts.

Our promise
Need Construction help in Ventura? Licensed & insured · free written estimates
Call (831) 604-3426
Local Service Coverage

Request a Free Estimate in Ventura

Tell us what you need - Sawyer Remodel Ventura responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch